1 / 1
Ear stretcher - 7mm and 9mm
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 7mm and a 9mm ear stretcher
- Rating
- 0 / 5
- Likes
- 26
- Downloads
- 291
- Makes
- 0
- Views
- 898
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Fashion Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I bought a kit (yes, that kit found also on Amazon) containing plenty of ear stretchers but when I reached size 6mm I noticed that the next piece was 8mm.
I created a 7mm and a 9mm stretcher.
You can use the o-rings from the kit. The o-rings of the 8mm fit the 7mm. I suppose the o-rings for the 10mm fit the 9mm too.
A few suggestions for printing:
- Use PETG (or TPU). Avoid PLA because bacteria will accumulate in between layers.
- I had good results with a brim > 15 lines and an overall speed of 40mm/s. Slower might be better. The parts tend to wiggle towards the point.
- I created a “post processing script” in Cura to slow down the print speed to 50% after layer 335. I'm using a 0.4 nozzle and a 0.1 layer height (for high resolution = less noticeable layers)