Disk Launcher (30ft+ !) 100% plastic
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Fun toy disk launcher I made as a fusion 360 project. It is fully 3d printable and uses a clamp system to launch a disk.
- Rating
- 3 / 5
- Likes
- 22
- Downloads
- 232
- Makes
- 1
- Views
- 1,390
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial
Fun toy disk launcher I made as a fusion 360 project. It is fully 3d printable and uses a clamp system to launch a disk.
Print settings
-No supports
-Brim for pin
-15% infill
-5 perimeters for the spring/squeezer! (helps for more power)
How to load the disk, and yes it should be hard to.
To load the disk in you might need to press it against a hard surface until it clicks. Make sure that the trigger is in its little pocket before putting in the disk (sometimes it will load with the trigger under the disk and it wont fire).