EZBake Magnetic Door Latch
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A door latched designed to fit inside the 2020 extrusion slot of Misumi extrusions, using 6x3mm magnets.
- Rating
- 5 / 5
- Likes
- 20
- Downloads
- 53
- Makes
- 1
- Views
- 725
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
This is a magnetic door latch, designed specifically for an Ezbake door (as can be seen here and in other Doom variations: https://github.com/FrankenVoron/Trident-EZBake) with the BOM extrusions with one flat side.
They print without supports, the little round things are ment to be popped out. This probably requires a somewhat tuned printer to work well as the overhangs are a bit steep and there's not a lot of clearance in the holes.
I did add some holes to use a SHCS M3x4 (or .. something, see picture of hole depth) but on my machine the press-fit was enough to keep them in place. If you do use these, be careful as the hole is on the smaller end of the scale so you don't split the model. The screw might actually need to be custom ground to the right length, this part of the design is far from ideal.
BOM
- 8 x n52 magnets per latch per side (you'll probably need a total of 4 latches at least so 32 magnets)
- I would highly recommend adding 1mm thick foam tape around the door to actually seal this thing (I use this - not an affiliate link: https://vi.aliexpress.com/item/32885016096.html)