1 / 2
Anti-Vibration Shock Absorber Damping Plate for MATEKSYS H743-SLIM Flight Controller (Updated) — image 1
1 / 2

Anti-Vibration Shock Absorber Damping Plate for MATEKSYS H743-SLIM Flight Controller (Updated)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Anti-Vibration Shock Absorber Damping Plate for MATEKSYS H743-SLIM Flight Controller for drones, planes, helis.

Rating
0 / 5
Likes
18
Downloads
222
Makes
0
Views
1,601
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

FAQ

I have built a X500 size quad-copter and I needed to reduce the vibrations to the MATEKSYS H743-SLIM Flight Controller as much as possible. This module will only fit the MATEKSYS H743-SLIM v2 and v3 flight controllers.

To complete this project you will also need the following:

You need to print only one Top Plate depending how the Matek H743-SLIM FC is connected to the ESC and GPS. If ESC and GPS is connected to the FC via JST connectors then use the “Top Plate using ESC & GPS connectors”. If the ESC and GPS wires are soldered to the FC pads then use “Top Plate using solder pads”. The bottom plate works with both Top Plates.

Recommendations

  • Use PETG as reacts better with higher temperatures and UV. The 3mf files are sliced using PRUSASLICER 2.6.0 beta3.
  • Clean the surfaces where the VHB tape will adhere with Isopropyl Alcohol.
  • Use a none sharp point to push the rubber balls to the plate holes. Careful not to puncture the rubber balls.
  • In the begging of a flight day, during the Pre-Flight also check that the VHB tape is fully adhered to the drone.
  • I do not recommend to bolt down the bottom plate as that will make the assembly semi-rigid and loose some of the anti-vibration properties.
  • After installing this assembly, hover in low altitude for a short time and check your IMUs vibration logs for any unusual picks etc.

Request

It will be most helpful if you can add a comment with plots before and after using this assembly and a short description of your equipment.

  • Drone model
  • FC
  • GPS
  • ESC
  • Motors
  • Props

Your input will be most appreciated and helpful for all flyers with similar configurations.

 

Update (06/07/2023): The PCB hole pattern dimensions were off by 0.5mm; fixed.

 

Enjoy!

Tags