1 / 6
Grips for Umarex Colt Government 1911 A1 airgun — image 1
1 / 6

Grips for Umarex Colt Government 1911 A1 airgun

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

After owning an Umarex Colt Government 1911A1 CO2 pistol (cal. 4.5 mm (.177) diabolo) I found that the right grip (CO2…

Rating
0 / 5
Likes
8
Downloads
66
Makes
0
Views
1,126
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

After owning an Umarex Colt Government 1911A1 CO2 pistol (cal. 4.5 mm (.177) diabolo) I found that the right grip (CO2 cartridge cover) moved around a lot and the grips are not that good so I intended to adapt wooden grips from real 1911 as the screw holes fit the replica (thanks Umarex for that).

But my wooden grips were very fragile so I decided to create a specific model for that pistol with tighter tolerances than the original flimsy rubber grips.

I made two versions of these, one pair with the notch at the bottom rear and one without that I think are better to rest your palm comfortably.

The "main" visual difference with the original (notch aside) is the groove for the mag release.

I don't have wooden filament but I suppose it is the way to go here.

Updates:

2021/04/21 I added a right grip with holes (4.1x3 mm) to insert your own dowel pins because it is easier to print.

2021/04/29 I added a pin that can be printed from the side to be strong and pressed in the "no pin" grip.

Print Settings

Printer:

CR-10 V3

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

20%

Filament:

DasFilament PLA

Metallic Rot

Category: Sport & Outdoors

Tags