Aquarium Airline Hose Connectors
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A collection of aquarium air pump hose fittings, though they can be used with any small diameter low-pressure air hose.
- Rating
- 4.75 / 5
- Likes
- 232
- Downloads
- 2,132
- Makes
- 2
- Views
- 5,273
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The Problem
I am re-doing the airline setup for my aquarium. I needed some of the little airline hose inserts and didn't have any, so my wife said "Why don't you print some?". I looked to do this, but couldn't find any pre-made STLs, so I took to designing them myself.
The Design
These were designed in Shapr3D. I measured an existing airline flow control valve and determined that the outside diameter of the nozzle tip, was 4.2mm, with a 2.5mm inner diameter. I replicated this as close as possible, with the nozzle starting at 7mm with a taper down to roughly 4mm and an inner diameter of 3mm.
The Print
I recommend printing these in PETG or another non-soluble filament (PLA will dissolve in the water over time, while not harmful to the fish, it will cause some grief).
I printed these at 0.15mm resolution at a speed of 70mm/s. I use Overture PETG with a recommended range of 230 - 250, I printed these at 245 to reduce stringing, you will likely need to come back with a heat gun after the print to clean them up.
I also recommend using organic supports on the T & Elbow and printing them upright, this gave the best quality IMO. See the pictures for ideas.