Ford Maverick Under-Seat Divider (FITS)
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.09 – €1.34 net (excluding VAT)
For file: FITS Divider Bracket A w heatsets.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.21 excluding VAT (range midpoint).
- Weight reported by the author
- 12 g
- Print time reported by the author
- 1.15 hr
- Source material
- ABS
- Estimate material
- ABS
- Estimate printer
- Bambu Lab X1 Carbon - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Divider for the Ford Maverick rear under seat compartment utilizing the FITS integrated mounts.
- Rating
- 4.833 / 5
- Likes
- 118
- Downloads
- 648
- Makes
- 6
- Views
- 3,473
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
This is a divider for the Ford Maverick rear under-seat compartment, it utilizes the Ford FITS integrated mounts.
The design is comprised of two main parts, the divider and the FITS brackets. The brackets bolt on to the divider using M3X20mm socket head cap screws. There are two variations of the bracket, one utilizing M3 heat set thread inserts, and one using M3 nuts. I prefer the heat set threads, but not everyone has them available. There are three types of dividers to choose from, the solid one is faster to print and may be a bit more sturdy, the hex one uses half as much filament and is a bit nicer aesthetically, but takes longer to print, and finally, I've included a split version of the solid divider to allow for printing on a smaller print bed. Print the half divider in the orientation it was created in, and provide supports to the build plate. The half divider is assembled using M3X12mm socket head cap screws and either M3 nuts or heat set inserts.
When printing the brackets, I would suggest using “supports everywhere” to ensure the screw holes print cleanly.
Ideally this would be printed in ASA or PETG, ABS is fine as long as it stays under the seat and out of the sun, PLA is not recommended as it may melt in a hot car.
This design is remixed from two designs on Thingiverse.
Original Bracket:
https://www.thingiverse.com/thing:5220213
Original Divider:
https://www.thingiverse.com/thing:5867982
I'd also like to thank user Remsv on Thingiverse for the parametric hexagon grid generator here:
https://www.thingiverse.com/thing:4594754