Omen 45L led holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Led holder for the bottom part of the case
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 11
- Makes
- 0
- Views
- 150
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
I absolutely hated that the bottom of the case was not covered by any light because of the GPU.
I used some MagFlex Lite because I
Those strips and splitter
Some double sticky tape (I used that one, it may be the only use it has otherwise it's pretty bad…)
I used 10% infill, tried 0 but it caused other issues.
I had to split the long part in half though it may fit on a 30x30cm bed and you can even print the full on a 40x40 bed.
Led heat don't seems to be an issue with 3 walls and 10% infill.
Orientation should be done according to the effect you want to “see”, I oriented mine ledside down as I use some “galaxy” filament that hide the layers even the biggest ones but using a PEO/textured sheet might give some good effects through the glass.