Hayward Pool Filter Label
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Label ring to replace the stick-on label for a Hayward Vari-flo XL pool filter
- Rating
- 5 / 5
- Likes
- 13
- Downloads
- 128
- Makes
- 2
- Views
- 932
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
The stick-on label on my pool filter went bad and peeled off. This is a printed replacement so I know which way to turn the lever for filtering, backwashing, etc.
Printed in PETG with a color change so that the words are more visible than a single color would be.
- PETG (any UV-stable filament should be fine)
- 0.1 mm layer height
- 75% fill (actually, this setting probably doesn't matter since it's just a few layers thick)
I recommend leaving the print on the bed plate till the plate has cooled. If you pull it off while it's warm, there's a chance the print will warp. I glued the label in place with a couple of drops of super glue.
The inner diameter could probably be a bit larger, say a millimeter or so. But it fit well enough that I didn't make the change. I've included the FreeCAD file so you can tweak as needed.