Hyperdrive Duo HD28C desk/shelf bracket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My MacBook Pro lives under my desktop TV stand, and this hub doesn't allow me to close the lid for my MacBook Pro.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 20
- Makes
- 0
- Views
- 748
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Noncommercial
My MacBook Pro lives under my desktop TV stand, and this hub doesn't allow me to close the lid for my MacBook Pro. I also created my own version of RVDD's grip replacement (https://www.prusaprinters.org/prints/50137-hyperdrive-duo-7in2-magnetic-grip-replacement/files) but sliding my laptop out to use the SD card reader kept bending the hub out and disconnecting my other devices, so I created this bracket which is screwed underneath my monitor stand/shelf.
Its a pretty tight fit due to the short lip at the back which holds it in place as I didn't want the hub to slide out when pushing a USB drive into it. I used the back of a Sharpie pen to push the hub fully into the bracket.
Print instructions
Sliced in PrusaSlicer in the default orientation, I only used supports up to the screw in tabs (including the screw holes). A support blocker was used at the top where the fillets are. Printed it in PLA at 0.2mm.