Watchy Case - Minty
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Minimal size Watchy case that is separated into a bottom shell and a thin flat top piece. Requires clipping the loops.
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 121
- Makes
- 1
- Views
- 1,517
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- GNU General Public License v3.0
This is a case for the SQFMI Watchy board.
It consists of a bottom shell that fully houses all components, a flat top piece that clips into the bottom, and buttons, of which you will need to print 4.
ATTENTION:
This case cannot house the board as is. You need to remove the top and bottom loop of the pcb using a dremel or clipper. This causes no further problems if done properly, but could break your watch if your board snaps or is otherwise damaged in the process.
This case comes in two variants:
glue - has no snap joints and thus needs to be secured with tape - printable on any 3D printer
snap joints - can snap together without tape, but likely needs a resin printer to print properly