1 / 2
Spool Winder
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A way to secure an empty roll to wind filament on there.
- Rating
- 5 / 5
- Likes
- 93
- Downloads
- 561
- Makes
- 8
- Views
- 6,580
- Reviews
- 8
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A way to use a drill for rewinding a roll of Filament for any reason that may happen. Using a half inch bolt and a power drill.
Material needed
Two of the winders3
½ inch bolt, I used one thats about 4 inches long
½ inch nut
½ inch washer x2
Drill
On the bolt it should go washer spool holder empty spool holder washer nut. Tighten the nut as much as possible. That is just a matter of feeding him and through the bottom hole and slowly spinning directing the filament so it's distributed evenly