1 / 8
7-Slot AR15 Vertical Mag Holder (Magnet or Screw Mount) — image 1
1 / 8

7-Slot AR15 Vertical Mag Holder (Magnet or Screw Mount)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Lancer and PMAG AR-15 Compatible Vertical Magazine Holders

Rating
5 / 5
Likes
221
Downloads
2,439
Makes
3
Views
7,272
Reviews
4

Updated at source:

Model information

Category
Accessories
License
Creative Commons — Attribution — Noncommercial — Share Alike

These seven slot, vertical, AR-15 magazine holders can be mounted with either a female threaded magnet, or screwed to the wall (pre-centered holes provided). If using magnets, I would recommend at a minimum three 25lb+ Neodymium magnets. I usually use two 50lb+ rubber coated Neodym magnets with M6 screws because the larger bases are more stable.

They are compatible with most AR-15/.223/556/.300Blkout magazines, including Lancer and PMags. The extended version has longer arms and can also hold two doublestack 9mm Glock, Springfield, etc. magazines in place of an AR-15 magazine.

While I built these models in Solidworks from scratch, I did base them off the model listed so a shoutout to those who came before me.

Recommended Printer Settings:
50%+ Infill (I usually do 80% to help combat flex, but 50% seems fine)
I recommend Supports - If you can do trees or organic from the heatbed to support the lip overhangs, that is best. Otherwise, I would recommend supporting the lip overhangs off of the print itself and I usually don't worry about the fillets.

**Requires Minimum 9.8 × 8.2 inches / 250 × 210 mm Print Area 

Tags