Header Tank Mod for HPI Savage X 4.6 / XL 5.9
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
a simple mod to solve the infamous half tank lean issue of the nitro savage
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 32
- Makes
- 0
- Views
- 1,009
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
solves the HTL problem by using a additional 60cc header tank used by nitro 3D helicopters.
plus it gives a longer runtime per tank, 160cc stock vs 220cc with this upgrade.
comes in 3 variants
V1 only for Savage X
V2 only for Savage XL
V3 universal for X and XL
pay attention to use the correct variant for your savage! see notes on the file section.
all parts are printed with PETG
for the X 4.6 you need:
1x brace v1
2x tank holder v1
2x m3x8mm screws
2x nuts
2x washer
2x slightly longer shock screws
for the XL 5.9 you need:
1x ziptie
2x tank holder v2
1x 102526 XL Rollcage (if your XL doesnt have one, X Cage WONT WORK!)
Note to brace v3 (for X & XL):
2x zipties
2x slightly longer shock screws
Brace v3 is intendented to ziptie on the tank straight to it, without the need to print 3 separate parts and additional screws.
of course you can also use the v1 & v3 on the xl aswell, but it is less protected when landing on the rear.
also prefill the header tank by using a syringe or a pump (as seen in the videos below), filling it up by using the start drill or pullstart is a pain :)
inspired by these mods seen here:
X Mod:
XL Mod: