1 / 5
Header Tank Mod for HPI Savage X 4.6 / XL 5.9 — zdjęcie 1
1 / 5

Header Tank Mod for HPI Savage X 4.6 / XL 5.9

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

a simple mod to solve the infamous half tank lean issue of the nitro savage

Ocena
0 / 5
Polubienia
3
Pobrania
32
Wydruki
0
Wyświetlenia
1016
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

solves the HTL problem by using a additional 60cc header tank used by nitro 3D helicopters.

plus it gives a longer runtime per tank, 160cc stock vs 220cc with this upgrade.

 

comes in 3 variants

  • V1 only for Savage X

  • V2 only for Savage XL

  • V3 universal for X and XL

pay attention to use the correct variant for your savage! see notes on the file section.

all parts are printed with PETG

 

for the X 4.6 you need:

1x brace v1

2x tank holder v1

2x m3x8mm screws

2x nuts

2x washer

2x slightly longer shock screws

 

for the XL 5.9 you need:

1x ziptie

2x tank holder v2

1x 102526 XL Rollcage (if your XL doesnt have one, X Cage WONT WORK!)

 

Note to brace v3 (for X & XL):

2x zipties

2x slightly longer shock screws

Brace v3 is intendented to ziptie on the tank straight to it, without the need to print 3 separate parts and additional screws.

 

of course you can also use the v1 & v3 on the xl aswell, but it is less protected when landing on the rear.

 

also prefill the header tank by using a syringe or a pump (as seen in the videos below), filling it up by using the start drill or pullstart is a pain :)

 

Get the 60cc tank here

 

inspired by these mods seen here: 

X Mod:

XL Mod:

 

Tagi