2x Hammer holder for Wall mount&storage system (Allit StorePlus)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Hammertime! This is a holder for 2 hammers to hang on your Wall mounting and storage system. It has a certain tendency…
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 57
- Makes
- 2
- Views
- 521
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Hammertime!
This is a holder for 2 hammers to hang on your Wall mounting and storage system. It has a certain tendency to slide sideways when you put your hammer back, so I made a little pushing pin to stop it from doing that. The fitment of said pin will rely heavily on your printer calibration, so I'll recommend to use scaling to make it work.
It prints lying on the side and will need some fan percentage to print nicely. No supports needed. You should print hot though, to assure layer adhesion. I recommend 0.6mm nozzle, 0.8mm extrusion width, 0.4mm layer height.
If you want to support my work, consider leaving a tip or a friendly comment here on Printables. :)
Category: Tool Holders & Boxes