1 / 2
Onboard Tool Storage for Fitnation Stationary Bike — image 1
1 / 2

Onboard Tool Storage for Fitnation Stationary Bike

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

This is just a basic tool holder for the Fitnation Flex Bike Express / Ultra. The bike came with a double open end…

Rating
0 / 5
Likes
1
Downloads
11
Makes
0
Views
303
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

This is just a basic tool holder for the Fitnation Flex Bike Express / Ultra.

The bike came with a double open end wrench, a hex wrench and a hex wrench screwdriver combo tool. I didn't use these tools when I assembled it for my wife, so was going to toss them, but then I thought I should keep them in case it goes back to QVC, or she decides to give it away or sell it sometime down the road.

Rather than to keep track of these three oddball tools, I made a simple holder to keep them with the bike, but out of the way. This holder attaches to the top of the frame just below the handlebar, using one of the 4 screws holding the handlebar to the frame.

Print Settings

Printer Brand:

Anet

Printer:

A8

Rafts:

No

Supports:

No

Resolution:

.2

Infill:

20%

Filament: Geeetech PLA Silk Silver


Notes:

It prints as oriented in the STL without supports.

Custom Section ==============

Installation:

Remove one of the two screws at the top of the frame on either side holding the handlebar assembly to the frame, push the screw through the holder, then reinstall the screw with the holder attached. I put this on the right side but it really doesn't matter... It may fit equally well on the seat back, or anywhere out of the way where there's a screw to hold it.

Category: Household

Tags