Reinforced HSW Dymo 160/280 Label Maker Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix of the Dymo Label Maker holder for the Honeycomb Storage Wall with added reinforcements
- Rating
- 5 / 5
- Likes
- 22
- Downloads
- 198
- Makes
- 4
- Views
- 806
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Remix of the HSW Dymo 160/280 Holder. Mount to hold the Dymo label maker on your Honeycomb Storage Wall.
I have been using the original version of this for a few months but found that it stretched over time and made the grip loose, to the point where I was afraid the label maker might fall off the wall. So I made a simple modification to add a bar across the front to help reinforce it. This holds the label maker a bit tighter and should prevent it from stretching in the future.
2023-11-22 Update: I added a Wide version of this. The width is increased by a few mm just to allow easier insertion of the label maker. It also lets it sit a bit lower, freeing up some space above it on your honeycomb wall. Added a picture of both.
Print Settings
Printer: AnkerMake M5
Filament: PLA+
Infill: 20% Gyroid
Perimeters: 3
Solid Layers: 5 top, 4 bottom
Supports: No supports required
Layer Height: 0.2mm