Ford Mustang Gen 6 (2015) Steering Column Control Module (SCCM) PCB housing
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Ford Mustang Gen 6 (2015) Steering Column Control Module (SCCM) PCB housing for projects using said car as a donor.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 17
- Makes
- 0
- Views
- 644
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Ford Mustang Gen 6 (2015) Steering Column Control Module (SCCM) PCB housing
Ford Mustang Gen 6 (2015) Steering Column Control Module (SCCM) PCB housing for projects using said car as a donor.
You need the SCCM for hi-beams and turn signals when using original BCM (Body Control Module). SCCM generates CAN bus signal to turn on and off said lights.
The challenge is, that the SCCM original housing is large. This project enables to shrink the whole system down to bare minimum.
While the parts in the previews don't look so self explanatory, once you disassemble SCCM and the turn signal switch, it becomes quite clear how it's used.
You do need to solder wires to the turn signal switch PCB. Everything is ground side switched. See the pictures below for the pinout.
SCCM part no based on which model was created: EG9T-14B522-BEW
Originally created as a part of Ford Mustang 1965 fastback restomod which uses 2015 Mustang components - engine, PCM, BCM, BCM-B, RTM, SCCM, BJB.
All questions and feedback welcome!
All modifications back to the community!