1 / 2
Filament spool stand using 608 bearings
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a filament spool stand using commonly available 608 bearings. It can hold spools up to 90mm wide.
- Rating
- 5 / 5
- Likes
- 31
- Downloads
- 191
- Makes
- 2
- Views
- 1,016
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
This filament stand will hold spools up to 90mm width during the print process. No supports required. I glued the Cross Ties to the Side Walls for security.
I suggest printing the Spindles at 0.15 layer height. Everything else at 0.2mm.
Just press the 608 bearing flush into the ends of each of the Spindles.
I placed some felt pads under the pads on the Side Walls to eliminate any rolling noise.