M365 rear tire valvestem cover
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I made this cover, to avoid small stone/debris getting inside the tyre that might cause a flat tyre. Correct…
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 41
- Makes
- 0
- Views
- 467
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Vehicles
- License
- Creative Commons — Attribution
I made this cover, to avoid small stone/debris getting inside the tyre that might cause a flat tyre. Correct airpressure is what I think causes most flat tyres, but this could be a soft spot too. Atleast on my m365, there is a lot of air between the rim and the tyre valve.
Printed in PLA, but TPU gonna be tested in the future.
If you need a nut, look for either a nut for schrader or dunlop valves ( both are same size).
If you cannot find a nut, try the "no.nut" file. It is a bit higher so the valvecap might push on it. Not tested at all, and I think it is only a last call solution, as the nut adds a better grib.
Category: Vehicles