1 / 6
M365 rear tire valvestem cover — zdjęcie 1
1 / 6

M365 rear tire valvestem cover

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I made this cover, to avoid small stone/debris getting inside the tyre that might cause a flat tyre. Correct…

Ocena
0 / 5
Polubienia
5
Pobrania
41
Wydruki
0
Wyświetlenia
469
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution

I made this cover, to avoid small stone/debris getting inside the tyre that might cause a flat tyre. Correct airpressure is what I think causes most flat tyres, but this could be a soft spot too. Atleast on my m365, there is a lot of air between the rim and the tyre valve.

Printed in PLA, but TPU gonna be tested in the future.

If you need a nut, look for either a nut for schrader or dunlop valves ( both are same size).

If you cannot find a nut, try the "no.nut" file. It is a bit higher so the valvecap might push on it. Not tested at all, and I think it is only a last call solution, as the nut adds a better grib.

Category: Vehicles

Tagi