Replacement top half umbrella bracket for CowboyStudio Swivel Tilt Bracket
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a replacement part for a photography umbrella bracket
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 11
- Makes
- 0
- Views
- 190
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution
This is a replacement part for the umbrella swivel bracket made by CowboyStudio and sold on this Amazon page:
https://www.amazon.com/CowboyStudio-Umbrella-Bracket-Swivel-E580EX/dp/B0034WR71G/
For both of the identical brackets I own, the bolt on top broke loose and started spinning easily. I designed this replacement part to use the existing hardware, plus a standard 1/4 inch 20 bolt approximately 1/2 inch long.
I printed these with the bolt face down, so the two arms stick up. Surprisingly, it printed well without any supports. It turned out fine with line supports as well. I think I used .15mm layer height, but this shouldn't matter much.
It feels just as sturdy, if not more sturdy than the original. And if this one breaks, I'll just print it again!
Print Settings
Printer:
Hictop Prusa i3
Rafts:
No
Supports:
Doesn't Matter
Resolution:
.1mm - .2mm
Infill:
30%
Notes:
Print with arms sticking up
Category: Camera