Desktop Shelf Spacer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I designed this because I needed more height for the shelf that is attached on my desk (I believe this is a desk from…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 16
- Makes
- 0
- Views
- 180
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
I designed this because I needed more height for the shelf that is attached on my desk (I believe this is a desk from early 2000s. I needed a 1" extension. All you need to do is measure and buy the appropriate length screws to match the additonal space you need with your design.
The holes for the hardware on this are designed for 1/4" wide x 1.5" long screws (think they are 1/4-20 screws for width and thread pitch). I needed a 1" extension, and the original screws were 1/2" long. You can scale this in the Z direction for this desk if you need less space than my 1" design, just make sure you buy the proper length screws.
Print Settings
Printer Brand:
TEVO
Printer:
Rafts:
No
Supports:
No
Resolution:
.25 layer height, 4 walls, 8 top and bottom solid layers
Infill:
30% (no more is necessary), 20% is probably ok
Filament: Matterhackers PETG Transparent Orange
Notes:
The print took about 11hrs at around 25-35mm/s.
* PETG (PLA is probably fine too) * 30% infill * 4 walls * 8 top/bottom layers (for a 2mm floor and ceiling)(this might matter if you put something heavy on your shelf)
Category: Office