Y Endstop Mount--Monoprice Maker Select/Wanhao DI3
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A mount for the Y axis endstop on the Monoprice Maker Select/Wanhao Duplicator I3.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 12
- Makes
- 0
- Views
- 146
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A mount for the Y axis endstop on the Monoprice Maker Select/ Wanhao Duplicator I3/ all of the other clones.
I modified the original file and added an extra hole that was 4 mm to the side because the mount wouldn't fit the original switch.
If you want to use the very back of your bed, you will need to have the screws in the holes closest to the switch.
Print Settings
Printer Brand:
Monoprice
Printer:
Maker Select
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Resolution:
Doesn't Matter
Infill:
100%
Filament: Doesn't Matter I used PLA
Notes:
This mount has two sets of holes. It works on an endstop that has the holes 10 mm apart. The original only could hold an endstop with the holes 6 mm apart.
You may need to widen the holes a little bit using a finish nail. For me, the holes were very tight.
The third image is a picture of a test that I printed but it was warped and I didn't use it. It looks bad, but it is the same size (a little thinner because it warped and had bad adhesion). I just didn't bother to take to good one off of the printer.
Category: 3D Printer Parts