Wall segment for Ambiano (or similar) dehydrator
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Wall segments to fit Ambiano (or similar) dehydrator for filament drying. Easy to disassemble.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 56
- Makes
- 2
- Views
- 324
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I purchased an Ambiano dehydrator from Aldi, model number FD-320 from the specials bin.
The existing clear trays (5 in total) are too shallow to hold a filament spool, so I needed to create a wall segment that could be disassembled for storage when the dehydrator was not in use. The tolerances are quite loose so it's easy to take apart.
The inner diameter of the circle is 90mm, with an outer diameter of 94mm. Adjust the scale factor for a custom-fit to your dehydrator.
There are a number of ribs that have been added to stabilise the printing process, as I noticed some earlier attempts would have layer shifts during the print. The wall thickness could potentially be thinner, but this works for me.
You will need to print six (6) of these segments for a complete circle. I have only printed 2 complete walls, as I don't think I will need to dry more than 2 spools at a time.
I printed these in PETG, but I'm sure most materials would be OK depending on your max dehydrator temperature. I printed this with the larger radius on the print bed and with supports on the overhang portion to ensure I had a sharp edge for the wall to sit properly on the tray.