Skadis - Parameterized L Holder (Machinist Squares, Double Squares, etc.)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
We've got a T holder. Some things aren't a T, though. Some of them have one leg lopped off. A half-T? Or an L?
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 99
- Makes
- 0
- Views
- 395
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Part of Ed's Skadis Shop Stuff collection, a set of Skadis holders and gizmos intended to have pleasant affordances and share common visual design elements. Fits the Skadis Universal Hook by CSD_Salzburg. Uses the Slide-Down Universal Hook Catch for Skadis by yours truly.
This thoroughly parameterized model (seriously, crack open the .f3d, you'll get a pile of things to tweak) is intended for hangin' L-shaped stuff on the wall. It helps a little if the short bit on top is a little heavier than the long bit on bottom, but it's not required.
In addition to the .f3d file (and an accompanying .step), we've got a couple of preexisting STL files. (As per a lot of the other stuff in this collection, links might be affiliate, ‘cause Jeff Bezos has nickels and I want ’em.)
- Shinwa 9cm machinist square (maybe my favorite measuring/calibration tool).
- iGaging 6" double square
- The 4" double square from that kit is TBP(arameterized).
As with most of Ed's Skadis Shop Stuff, these tool holders look pretty good with a filament swap after the 3mm mark.
Please note: all my Printables models that are not a remix of others' work are licensed CC-BY-NC-SA. Commercial usage is available upon request; please reach out via email.