Photon Mono exhaust adapter
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Adapter for the Photon Mono SE and probably other Photon Mono variants to magnetically attach a fume extraction hose.
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 38
- Makes
- 0
- Views
- 543
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
With these 2 parts printed in FDM or SLA you can magnetically attach and detach a hose to extract the fume from the Photon Mono SE (and probably other Photon Monos but I only tested on the SE). I used an instruction to redirect the fumes to the back of my printer but I was not able find the instructions as I am creating this part. But I hope it is useful anyway.
Instructions:
Each part needs 10 of the magnets pressed in the small holes. For me they stayed in without glue but if that does not work for you use a small drop of glue. When inserting the magnets, take care of the orientation so that both parts will later attach correctly.
The vent_screwOn.stl can be screwed to the printers backside with the 4 screws.
Use the hose clamp to attach the hose to the vent_tube.stl, be careful to tighten the clamp enough that it is holding the hose but not to much otherwise the printed part will break.
Parts needed:
4x m3 screws 5 mm to 10 mm long
1x 100mm hose
1x hoseclamp
20x magnets wih 2mm thickness and 4mm diameter