Photon Mono exhaust adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter for the Photon Mono SE and probably other Photon Mono variants to magnetically attach a fume extraction hose.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 543
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
With these 2 parts printed in FDM or SLA you can magnetically attach and detach a hose to extract the fume from the Photon Mono SE (and probably other Photon Monos but I only tested on the SE). I used an instruction to redirect the fumes to the back of my printer but I was not able find the instructions as I am creating this part. But I hope it is useful anyway.
Instructions:
Each part needs 10 of the magnets pressed in the small holes. For me they stayed in without glue but if that does not work for you use a small drop of glue. When inserting the magnets, take care of the orientation so that both parts will later attach correctly.
The vent_screwOn.stl can be screwed to the printers backside with the 4 screws.
Use the hose clamp to attach the hose to the vent_tube.stl, be careful to tighten the clamp enough that it is holding the hose but not to much otherwise the printed part will break.
Parts needed:
4x m3 screws 5 mm to 10 mm long
1x 100mm hose
1x hoseclamp
20x magnets wih 2mm thickness and 4mm diameter