1 / 1
Camera Flash Hotshoe Cover
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A 5-minute print which allows you to cover the hotshoe mount on your camera to protect the connector pins from dirt.
- Rating
- 5 / 5
- Likes
- 17
- Downloads
- 150
- Makes
- 6
- Views
- 515
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This hotshoe cover is designed to protect the small pins on your camera's flash mount from dirt and potential damage. It is a quick (less than 5 minute) print without the need for supports or post processing.
Printing Instructions
- 1x wall loop (this is necessary to allow good bridging of the connector cover).
- 5x top and bottom layers.
- 40%+ infill
I recommend printing this part using ABS or PLA, however printing this out of TPU with 2-5% increased scaling can give you a more weather resistant seal if that's what you're looking for. PETG should work well if your printer can complete a 12mm unsupported bridge without sagging.