1 / 6
Case for FrSky G-RX6 receiver
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A quick-to-print case for the FrSky G-RX6. Provides proper protection.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 60
- Makes
- 0
- Views
- 598
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
A quick-to-print case for the FrSky G-RX6. Provides proper protection.
The signal pins for CH's 1 & 6 are marked with a small dot.
Instructions:
- Print the two parts of the case
- Remove card wrapper from receiver, cut a piece 21 x 18 mm - this will be the new bed
- Save the piece of foam under the pressure sensor.
- Place the card from step 2 into the base, then the board, then the foam
- Secure the two parts of the case with tape or cyano
- Apply hot glue to the antenna exits
Done!
See also my case for the RX6R
Print Settings
Printer Brand:
Creality
Printer:
CR-10 Mini
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.16
Infill:
Use default (not critical)
Filament: Any PLA Any
Notes:
Best with standard 0.4mm nozzle
Category: Models