Pulley Cover for AnyCubic i3 Mega (rear only)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a pulley cover for the rear Y axis pulley on the Anycubic i3 Mega (I guess it's a gear attached to a stepper…
- Rating
- 4.889 / 5
- Likes
- 27
- Downloads
- 292
- Makes
- 10
- Views
- 1,003
- Reviews
- 9
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a pulley cover for the rear Y axis pulley on the Anycubic i3 Mega (I guess it's a gear attached to a stepper motor, not exactly a pulley, but that's what everyone is calling it so we'll go with that)
I decided I wanted some pulley covers, and I found one that someone else made for the front, but not too many for the rear. I didn't like the look of the ones I did find for the rear, and the one I tried sat higher than I liked, and also didn't stay flat well because it was only held down on one side. This is a bit lower profile, and attached with two screws to help keep it lying flat.
Check out my other Anycubic i3 Mega accessories at: https://www.printables.com/social/55222-tyler/collections/95780
Print instructions
Printer Brand: Anycubic
Rafts: No
Resolution: 0.15
Filament: Filaments.ca EconoFil PLA (Black)
Notes: Print it in the supplied orientation. It requires a lot more support than if you flipped it upside down, but it ends up looking a lot nicer this way in my opinion.
If this design was useful to you, please post a make!