1 / 1
Pulley Cover for AnyCubic i3 Mega (rear only) — zdjęcie 1

Pulley Cover for AnyCubic i3 Mega (rear only)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a pulley cover for the rear Y axis pulley on the Anycubic i3 Mega (I guess it's a gear attached to a stepper…

Ocena
4,889 / 5
Polubienia
27
Pobrania
292
Wydruki
10
Wyświetlenia
1003
Oceny
9

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is a pulley cover for the rear Y axis pulley on the Anycubic i3 Mega (I guess it's a gear attached to a stepper motor, not exactly a pulley, but that's what everyone is calling it so we'll go with that)

I decided I wanted some pulley covers, and I found one that someone else made for the front, but not too many for the rear. I didn't like the look of the ones I did find for the rear, and the one I tried sat higher than I liked, and also didn't stay flat well because it was only held down on one side. This is a bit lower profile, and attached with two screws to help keep it lying flat.

Check out my other Anycubic i3 Mega accessories at: https://www.printables.com/social/55222-tyler/collections/95780

Print instructions

Printer Brand: Anycubic
Rafts: No
Resolution: 0.15
Filament: Filaments.ca EconoFil PLA (Black)
Notes: Print it in the supplied orientation. It requires a lot more support than if you flipped it upside down, but it ends up looking a lot nicer this way in my opinion.

 

If this design was useful to you, please post a make!

Tagi