CHOP3D DIY Filament Dryer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My specially created diy filament dryer.
- Rating
- 0 / 5
- Likes
- 42
- Downloads
- 74
- Makes
- 0
- Views
- 2,447
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Filament dryer. I am very pleased. create up to 80C in the chamber.
1mmStahl schablone.DXF serves as a template. I took 1mm steel and had it lasered. So all screwing points are given.
-----------------------------------------------------------------------------------------------------------
You need :
2020 Extrusions , check for local supplier
4x290mm
2x560mm
2x240mm
https://shop.bohrers.de/testartikel-zuschnitt-neu-100m-573-575.html
-----------------------------------------------------------------------------------------------------------
Power Supply https://amzn.to/43zgaUE
-----------------------------------------------------------------------------------------------------------
M4 2020 T nuts. https://amzn.to/44MuydX
-----------------------------------------------------------------------------------------------------------
Some Corner brackets https://amzn.to/3qan05w
-----------------------------------------------------------------------------------------------------------
A PTC Heater https://amzn.to/43wArKQ
-----------------------------------------------------------------------------------------------------------
16 Bearings 608zz https://amzn.to/44WmFSV
-----------------------------------------------------------------------------------------------------------
IEC connector https://amzn.to/3pPt7MD
-----------------------------------------------------------------------------------------------------------
A Crimping Tool and Cable Shoes https://amzn.to/43y7T3x
-----------------------------------------------------------------------------------------------------------
some Melt in Nuts https://amzn.to/3q110dj
-----------------------------------------------------------------------------------------------------------
2 Fans 12v/24v https://amzn.to/46Xw5z3 or https://amzn.to/43Ew7ZL
-----------------------------------------------------------------------------------------------------------
some Thermistors https://amzn.to/3Y1mBPj
-----------------------------------------------------------------------------------------------------------
a BME280 https://amzn.to/44TYh42 for checking Temp and Humidity
-----------------------------------------------------------------------------------------------------------
Silica Gel ,self-regenerating https://amzn.to/3rypzyG
-----------------------------------------------------------------------------------------------------------
1 sheet of 20mm insulation such as
https://www.bauhaus.info/hartschaumplatten/ursa-hartschaumplatte-xps-eco-d-n-iii-pz-i/p/28877905
-----------------------------------------------------------------------------------------------------------
A Printer Mainboard with Mosfet for the Bed Heater Like :
-----------------------------------------------------------------------------------------------------------
Two MDF Plates :
Base :
600x280x19mm MDF
Back :
606x313x19mm MDF
-----------------------------------------------------------------------------------------------------------
8mm ,880mm aluminum round rod you need 8X110mm pieces
-----------------------------------------------------------------------------------------------------------
Another important piece of information for the PTC heater. a thermistor with a cap must be installed in it. unfortunately this has to be done by DIY. but then PID tuning is possible afterwards.