Paracord Handle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple, ergonomic handle to accommodate 4mm paracord.
- Rating
- 5 / 5
- Likes
- 51
- Downloads
- 178
- Makes
- 4
- Views
- 714
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
This is a simple handle to accommodate 4mm paracord, intended to be at the end of a loop. I intend to use these to pull 14" high storage bins out from under the bed, which may or may not contain moderately heavy things (extra blankets, unopened filament, etc).
Once the paracord is fed through and position adjusted, a few drops of CA glue on either side near the front end may be helpful to keep cord in place.
Model is already in intended print orientation, but change print orientation at your discretion. No supports or brims necessary. I'm printing mine at 6 walls, 30% Cubic, ABS. Your mileage may vary.