HMS Spool Carrier - the one to carry all of them spools we stack!
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
is it a bird? is it a plane? no, it's a spoolholder! jokes aside, it's THE spoolholder. tremendous, glorius, beast!
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 17
- Makes
- 0
- Views
- 240
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
i needed some fitted spool holders for the cabinet below the printer.
seeing the simple design @JERRY created for the IKEA SAMLA box, I redesigned it to fit my needs.
This now fits into drawers, on shelves, into cabinets or just onto your workbench or countertop.
depending on the length you need, print 2 ends and a mid part at least every 25 cm to support the alu rod or pipe (8mm diameter).
the end pieces have a snuck fitting, just rotate the rods in.
the mid parts have a slightly bigger hole to make it easier to slide on.
during testing I printed some 8mm pla rods, that were (suprisingly) indestructible without brutal force. so if you're desperate, can't wait or broke, just print them - just make sure to give them 1,5mm walls and 25% infill at least. in addition, reduce the distance between the mid pieces from about 25 to 15cm this will allow shorter rods as a positive sidekick. also, good luck on bedslingers...