Mantle Clock Style KNOMI Enclosure
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I did not want to install KNOMI in my toolhead, but I do like the display. I created a Mantle Clock style enclosure.
- Rating
- 0 / 5
- Likes
- 39
- Downloads
- 80
- Makes
- 1
- Views
- 1,058
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
I have included a version with the Voron logo and a blank version. I printed this using 4 walls and .4 layer widths with 40% infill. No supports needed.
The modules are a fairly tight fit to hold them securely. I ended up using a folded piece of thick paper under the battery to make it fit snug. The back cover fits snuggly inside tabs on the case. I found it's easiest to fit the bottom edge in like shown in the pictures and then raise the top up and sort of force fit into the tab. I use an exacto blade to pop the case open again. Just be careful not to scratch the outside of the case!!!
Parts include:
Battery: https://www.amazon.com/dp/B08ZCQXFX4?psc=1...
Adjustable Boost Module: https://www.amazon.com/dp/B0B6HZL9L9?psc=1...
Battery Charger Module: https://www.amazon.com/dp/B07PKND8KG?psc=1...
1 small 8.3mm x 13.3mm on/off switch.
Filament is the Flashforge Burnt Titanium PLA