Pool Toy - Torpedo Hollow and Screw-On
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Torpedo can be filled with any desired weight and then screwed on closed for lots of pool time fun
- Rating
- 4.833 / 5
- Likes
- 37
- Downloads
- 367
- Makes
- 6
- Views
- 1,228
- Reviews
- 6
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Fun Screw-On pool torpedo that glides smoothly through water! You can change the weight of the torpedo depending on whether you would like it to glide or sink more. I used coins, such as pennies, to weigh the torpedo down. Make sure to orientate model in slicer so that flat spots are on buildplate.
Disclaimer: Once Printed, the screws might be a little tight. Slowly insert the screw and turn it in and outwards to create friction and wear out the pieces so they fit smoothly.
Print Settings
Supports: HIGHLY Recommended for the overhang on the screw section (but not necessary, just wont look as smooth)
Material: PLA ( Stronger plastics might last longer)
0.2mm Layer Height
3 Walls (For strength since it will take a beating)
15-20% infill (Preferably more, the stronger side)
Printer: Voxelab Aquila X2