1 / 7
Updated Creality Runout Sensor Swivel Mount (Ender 3/Pro) — image 1
1 / 7

Updated Creality Runout Sensor Swivel Mount (Ender 3/Pro)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Mount the filament runout sensor to the top bar for direct drive upgraded machines. Three options available.

Rating
5 / 5
Likes
41
Downloads
268
Makes
2
Views
1,490
Reviews
3

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

December 19, 2024 Update:

There was a serious problem with the design that I did not account for and that is strain relief on the end of the cable. The wiring crimps inside my connector snapped from the repeated movement, so I redesigned the sensor plate to include a boss with ziptie slots to secure the wire so that the connector won't be the point of flex.

I HIGHLY recommend updating your print as soon as possible with this new mounting plate to avoid damage to your connector.

April 16, 2024 Update:

Additional designs were created to allow for the sensor to have a two axis pivot. Two sizes were created one the same width as the original single axis mount, and a compact mount.

Build Info:

For this build you will need:

  • (some M3 bolts in various sizes depending on the size choice)
  • 4 M3x16
  • 2 M4x16
  • 2 M4 T-nuts
  • 1 608 bearing

Print all the parts using the settings of your choosing. I recommend 1mm top/bottom, 1.2mm walls, and 15-25% infill. You can use an M3 tap to tap the 5 holes in the sensor mounting plate, or let the screws cut their own threads.

Press the bearing into the back of the main plate with the flange on the side facing you. The side with the flange will be the front. Press the sensor plate through the center of the bearing from the front and using the M3x8 screw attach the clamping plate to the backside to hold the sensor plate firmly to the bearing.

Using the 4 M3x16 screws attach the Creality sensor to it's mounting plate in the correct orientation, making sure the arrow imprinted on the cover is pointing down as shown in the pictures.

Insert 2 M4x16 screws and loosely attach the T-nuts to the back of the main mounting plate. Slide the T-nuts into the 2020 top extrusion and position the sensor approximately in the center, or wherever makes the most sense for your setup, and you should be done with the physical installation. Feed the filament through the sensor before loading your direct drive.

This guide was written from the perspective of a build where the sensor was previously used before upgrading to a direct drive. If the runout feature is not enabled in your current firmware you will need to flash updated firmware with it enabled, but that is beyond the scope of this Printable.

Please post your makes, and comment your suggestions.

Tags