Vertical holder for 19mm shelf
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a simple holder to hold a 19mm thick shelf upwards. I use it to keep my dog away from rooms he should not enter.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 15
- Makes
- 0
- Views
- 112
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Living Room
- License
- Creative Commons — Attribution — Noncommercial
This is a very simple holder for 19mm standard shelf boards to hold it upright. I use the standard IKEA board for Pax wardrobes (100cm width) as a room separator to keep our dog out of areas he should not enter (i.e. childrens' rooms, bathrooms etc.). I use two holders per board. See attached photo.
I have uploaded a revised version without the small void on the bottom - with this, there was too much local strain leading to breakage.
I also uploaded the bgcode for Prusa Mini with input shaper - PLA runs @ 215°C.
I printed in PLA, 2 walls, 15% grid infill and a modifier at the bottom with 30% honeycomb infill to make it stiffer.