Pegboard Brackets for Tools

This is a collection of brackets designed for use with the generic interlocking pegboard system that seems to be available from a variety of vendors such as Lidl, Parkside, VonHaus and TecTake, among others.

I believe they're pretty-much interchangeable between the systems mentioned above, but obviously haven't tested them all, so I'd suggest that you first check the hole spacing above against your system and then print one of the smaller brackets as a test before getting too happy with any of the larger prints.

The large holes centre-to-centre dimensions based on my measurements are:

• Horizontally: 38.5mm
• Vertically: 25mm.

The major design goal ideas behind most of my designs tend towards trying to minimise the use of supports and reduce plastic waste as much as possible, so I combine short M5 bolts with the plastic brackets, using the bolt heads to retain the brackets - 8 to 12mm works pretty well, depending on how thin the backing wall is. You can then adjust how tightly you want the brackets to fit by rotating the bolts to your preference.

One thing to be aware of, especially where I've put groups of designs into folders together, if you see various files with essentially the same names, but with a different version or iteration designations such as - v1, or, - i2 at the end, you should probably use the one with the highest number as these versions tend to be more refined.

Questions are welcome and I'll try to help where I can.