1 / 9
Original Prusa Enclosure (OPE) - Door Seal Heat Retention — image 1
1 / 9

Original Prusa Enclosure (OPE) - Door Seal Heat Retention

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Up your 3D printing setup – with better Heat Retention for the Original Prusa Enclosure (OPE)

Rating
4.941 / 5
Likes
159
Downloads
435
Makes
28
Views
2,909
Reviews
34

Updated at source:

Model information

License
Creative Commons — Attribution

Key Features of the Door Seal

  1. Add Heat Retention: Our door seal brings the heat, literally. It's all about insulation, creating a stable printing zone that spells primo print quality.
  2. Reduce Drafts: Reduce unwanted temperature shifts, the sneaky culprits behind print warping and quality blips.
  3. Peace and Quiet: Dampens the printing symphony, making those 3 AM print sessions way more friendly.
  4. Easy Peasy Install: No fancy tools required. Our door seal slides in like a breeze.

Get Sealing Today 🚀

 

Choosing Model Files

Does your Enclosure come with the Mechanical Lock Addon?

No → Folder A

Yes → Folder B

A - Door Left Bracket + Flex Seal

  • Door Left Bracket - Top (without Lock)
  • Door Left Bracket - Bottom (without Lock)
  • Flex Seal - Top (without Lock)
  • Flex Seal - Bottum (without Lock)

B - Door Left Bracket + Flex Seal (Mechanical Lock-Addon)

  • Door Left Bracket - Top (with Lock)
  • Door Left Bracket - Bottom (with Lock)
  • Flex Seal - Top (with Lock)
  • Flex Seal - Bottum (with Lock)

 

Print Instruction

Recommended print material:
  • for Brackets: PETG, ABS/ASA
  • for Flex Seal: TPU

 

Additional Parts needed:
  • 2x M3x12 screws (Use Spare Parts from Prusa Enclosure)

 

Installation

  1. Inside the left door remove the top M3x8 screw and the upper M3x12 screw from the door handle.
  2. Take part “Door Left Bracket - Top” and use two M3x12 to screw it in, don't tighten it yet.
  3. Slide the “Flex Seal - Top” between Bracket and Plexiglass with the U-shape facing to the front.
  4. Tighten the screws. Top half done!
  5. Follow same principle for the bottom half.
  6. Check fitment: You may have to adjust Flex Seal up/down, if the doors don't close properly. 
  7. Enjoy! 😄


Tested with PETG for Brackets and TPU Shore 85A for Flex Seals

Tags