Magazine loader rfox.eu v2.0
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Small and more ergonomic magazine loader for 9mm.
- Rating
- 4.8 / 5
- Likes
- 89
- Downloads
- 787
- Makes
- 10
- Views
- 2,458
- Reviews
- 10
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Small magazine loader, which will save you some pain from loading.
Use your thumb to press it down and up like this:
I recommend printing this with a glue stick applied to your printing area. Gcode has a 2cm of skirt added because I encountered a lot of tearing and spaghetti during prints.
The model can be printed just with minimal organic supports to save time and filament.
This model was originally based on 9mm and Sig P320/P229 Doublestack Speed Loader, but I've tweaked it based on the feedback from my friends. Especially my female friend gave me quite good feedback (too big, hard to handle and so on). After several iterations, I've finally arrived at this version.
Also f**k you G-l-o-c-k, I am just saying it is compatible, not that it is yours:
Hello, dear user. We have received a copyright infringement notice concerning your model.
G-L-O-C-K, Inc. (“G-L-O-C-K”) is the owner of registered trademarks. As you are no doubt aware, these trademarks are used to identify, advertise, and promote G-L-O-C-K’s products and activities without having obtained prior written authorization.