Levoit 300 series filter adapter for 140mm fan
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I wanted to use the 300 series toxin filter so I designed this simple adapter.
- Rating
- 0 / 5
- Likes
- 14
- Downloads
- 77
- Makes
- 0
- Views
- 784
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Share Alike
My room does not have good ventilation and I have to run a large 500cfm fan through a duct to a small gap in the only window of my workshop so I am always looking at ways to filter the air from printing and especially since I started to resin print. I did buy the Levoit LV-H28 and it works well, but has an annoying soft power switch so I can forget to turn it on. While looking at the bigger 300 series models I saw the Toxin removing filter and decided to buy that and a 140mm fan with very high static pressure designed for radiators. both arrived from amazon and I quickly tested a pressure fit from the 3d printed part to the filter and then finished the 140mm fan mount on the top. The filter has a foam seal so with the very good pressure fit only the fan needs a gasket of some sort to make sure the air is pulled through the filter.
The fan I used is a Artic P14 PWM PST 140mm fan 12v with 2.4 mm/H2o
Filter is the Levoit Core300-RF-TX but any of the 300 series filters will work.