Starsense Explorer Finder Shoe Mount / Holder for Vixen and Bresser/ES
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Finder Shoe mount / holder that allows for fitting of (some) Starsense Explorer brackets.
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 142
- Makes
- 1
- Views
- 1,914
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Physics & Astronomy
- License
- Creative Commons — Attribution — Noncommercial
Adapter to hold Starsense Explorer dock from Celestron telescopes.
Should be compatible with the unit from the LT80, LT70, LT114, 8", 10" and 12" Dobsonian models. Basically the ones that have the drop in wedge.
- Completely updated the design. Now a 3 component build that allow the starsense unit to be attached to a finder shoe either from the bottom or the side of the starsense unit.
- Weird design allows one side bracket to work on either side. Attached using and M5x35 Hex bolt
- 2 Designs for the holder. One uses threaded brass inserts, the other uses slightly undersized holes/nuts for the side mount.
- Bottom mount held on with nut and M5x20 hex bolt and nut.
- Threads and hole sizes compatible with the M5 thumb screw that comes with the starsense unit.
28.02.24: A slight update to the design. The finder shoe base has been revised as it was sized for both of my scopes, however I've since found out that it doesn't fit all scopes. The new design is more compatible. Design has also been revised so that nut can go either mount or shoe side. This should help if you want to mount it to (for example) a vixen dovetail.
29.09.2024: Updated the finder base to smooth some of the angles and increase the tolerance on the nut. It doesn't need to be retained by friction and is easier to install.
13.10.2024: Added based for user with Bresser/Explore Scientific Finder Shoes. Thanks to SecondTimeAround for the support in getting this done!
17.10.2024: Further increased the tolerance on the nut on the base.
20.10.2024: Updated the design of the holders. Existing design was just too short to allow the use of 10mm long Threaded brass inserts. This was extended by 1.5mm to allow them to be used and required a slight tweak of the side holder. As the side holder was tweaked so the nutty holders were tweaked
23/10/2024: Updated the holder again. Previously had a recess for a hex nut that just fit the head of the hex bolts I had. Ordered some more and the heads were slightly bigger and didn't fit so changed the hole to a circle and made it slightly larger.
Old Designs retained for historical purposes.
There are 3 components:
- Dovetail bases. Attaches to bottom with M5x20 hex bolt.
- Side attach bracket. Mirror symmetrical so can be used for LHS and RHS mounting. Available in one build that can accept threaded brass inserts and another which uses an undersized hole and hole for a nut.
- Starsense Unit Holder/dock. Holds the Starsense Unit. Available with a rather fetching angled sort of bottom that looks nice with the bottom dovetail on and with a flat bottom which makes it stand up a bit better.
The internal base and the top is angled so it mates nicely with the Starsense dock. If you want these faces to look nice then I suggest (in Prusa Slicer) using the ‘Place on Face’ command on the top of the unit and then rotating 180 degrees and print with supports on build plate only. This will leave the bottom a bit rough but nobody will notice.
Works best for me in PLA with 0.15mm.
