Filamentrollenadapter V2 (geteilt) für Kugellager 608 (8mm Bohrung) !neue / verbesserte Version in meinen Entwürfen verfügbar!
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This roller adapter can be equipped with a ball bearing of size 608 ZZ or 608 2RS.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 28
- Makes
- 0
- Views
- 217
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This roller adapter can be equipped with a ball bearing of size 608 ZZ or 608 2RS.
3 cylinder head screws M3x10mm and 3 nuts M3 are required.
By the seat of the bearing in the middle of the two parts it can not slip out to the side.
The outside diameter of the bearings is 22mm
The inner diameter of the bearings is 8mm.
The notch on the underside of the two parts makes it easier to lift off the heating bed.
Dieser Rollen-Adapter kann mit einem Kugellager der Größe 608 ZZ oder 608 2RS bestückt werden.
Es werden 3 Zylinderkopfschrauben M3x10mm und 3 Muttern M3 benötigt.
Durch den Sitz des Lagers in der Mitte der beiden Teile kann es nicht zur Seite herausrutschen.
Der Aussendurchmesser der Lager ist 22mm
Der Innenduchmesser der Lager ist 8mm.
Die Kerbe auf der Unterseite der beiden Teile erleichtert das Abheben vom Heizbett.
Print instructions
Category: 3D Printer Accessories Summary
This roller adapter can be equipped with a ball bearing of size 608 ZZ or 608 2RS.
3 cylinder head screws M3x10mm and 3 nuts M3 are required.
By the seat of the bearing in the middle of the two parts it can not slip out to the side.
The outside diameter of the bearings is 22mm
The inner diameter of the bearings is 8mm.
The notch on the underside of the two parts makes it easier to lift off the heating bed.
Dieser Rollen-Adapter kann mit einem Kugellager der Größe 608 ZZ oder 608 2RS bestückt werden.
Es werden 3 Zylinderkopfschrauben M3x10mm und 3 Muttern M3 benötigt.
Durch den Sitz des Lagers in der Mitte der beiden Teile kann es nicht zur Seite herausrutschen.
Der Aussendurchmesser der Lager ist 22mm
Der Innenduchmesser der Lager ist 8mm.
Die Kerbe auf der Unterseite der beiden Teile erleichtert das Abheben vom Heizbett.