Tipi Spool holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
It's a spool holder for Prusa mendels. It looks a bit like a tipi so that's why I named it that.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 17
- Makes
- 0
- Views
- 195
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
It's a spool holder for Prusa mendels. It looks a bit like a tipi so that's why I named it that. Two of these baby's in combination with a piece of 8mm rod will hold spools up to a radius of 10cm. The feet will 'snap' onto the top of your Prusa and the rod should pop in snugly so this is a complete toolless design!
Print instructions
Category: 3D Printer Accessories Summary
It's a spool holder for Prusa mendels. It looks a bit like a tipi so that's why I named it that. Two of these baby's in combination with a piece of 8mm rod will hold spools up to a radius of 10cm. The feet will 'snap' onto the top of your Prusa and the rod should pop in snugly so this is a complete toolless design!
Instructions
Print two of the holders. Pop in a piece of rod and in between your spool. Snap the feet onto the top of your printer. Enjoy. Like. Share.
.scad file is included, so you can adjust it if you want, for instance, you could make it slightly higher to accomodate bigger spools.