Case for Libre Computer Board ROC-RK3328-CC (Renegade)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This remix of the snap fit case can hold a 30x30x7mm fan and the lid is screwed on.
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 122
- Makes
- 1
- Views
- 684
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
I liked the design of the original case, and it fits well, but the lip of the bottom part comes off after disassembling once or twice. So i remixed the case, so that the lid can be screwed in place. In this version you can also mount a 30x30x7mm fan. The Mesh-Filter is optional.
Materials needed:
4 M3x10mm BHCS (for the Lid)
4 M3x5,7mm Heatsets (for the Lid)
4 M3x14mm BHCS (for the Fan, 12mm long also work - just a little short)
4 M3 Hexnuts
4 M3x4mm BHCS (for the board, same as for the original case)
To print the optional mesh for the fan import the lid and add the filter as a part. The Lid-Outline in the filter stl is only to check alignment, and shoud be below the print-area. Make sure the mesh is printed only with infill, no top or bottom layers.