1 / 5
Ruleman 605(bearing) con bolillas de 5mm(3/16) 5mm — image 1
1 / 5

Ruleman 605(bearing) con bolillas de 5mm(3/16) 5mm

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Ruleman con centro de 5mm , 20mm de espesor y 15mm de alto lleva bolillas de acero de 3/16 o 5mm si pueden ser delrin o

Rating
0 / 5
Likes
4
Downloads
35
Makes
0
Views
434
Reviews
0

Updated at source:

Model information

Category
Test Models
License
GNU General Public License v2.0

Ruleman con centro de 5mm , 20mm de espesor y 15mm de alto
lleva bolillas de acero de 3/16 o 5mm si pueden ser delrin o acetal pom mejor 
el de la foto es en petg es para bajas revoluciones a menos que lo hagas en acetal POM o nylon 6 , nylon 12 o policarbonato.
en mi caso lo hice con petg podria hacerse con abs pero para usos livianos en ese caso 
pueden colocarse por la ranura la bolillas y mantenerse con los aros 
no muy apretados y una vez colocados
se mantienen cerrados por las tapas superiores

Bearing with 5mm center, 20mm thick and 15mm high
It takes 3/16 or 5mm steel balls if they can be delrin or acetal pom better
It is for low revs unless you do it in this material or nylon, max nylon 12 or polycarbonate.
in my case I did it with petg it could be done with abs but for light uses in that case
the balls can be placed through the slot and kept with the rings
not too tight and once placed
are held closed by the top caps

Tags