Ender 3 Bed Quick Disconnect
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement for the stock bed cable strain relief mount that adds quick-release connections to allow unplugging the bed.
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 17
- Makes
- 0
- Views
- 248
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Replaces the stock Ender 3 bed wiring strain relief mount to add quick disconnect connectors. Designed to work with johnniewhiskey's popular drag chain and my wiring channel mount. Power is supplied through XT60 connectors, and thermistor wires are attached using Molex Micro-Fit. The bed-side Micro-Fit connector is a bit janky, because you have to solder wires directly to the legs of a board-mount connector, but once it's assembled there's no strain or motion on the cable, so it should be fine. The XT60 connector provides enough friction to hold the connector together without a need for any latch, but the Micro-Fit provides a latch as well, so it makes a really solid connection. Two small support structures built into the cable side model need to be cut out in order to insert the Micro-Fit connector.
XT60 Connectors:
Panel Mount Male (Bed side)
Snap-Fit Female (Cable side)